CF62 unlocking with no TP

Subject: CF62 unlocking with no TP Thu Jun 05, 2008 5:02 am

CF62, MC60, C60 & M55 "NO" Test Points

--------------------------------------------------------------------------------

After reading many theards on this issue:
I have come to reason that the same solution (software) works for all four
phone types: CF62, MC60, C60 & M55.

I copied and edited the following from (www.unlockeasy.net)
Please Note: went using KEYWORDs "Siemens (phone of choice)" means the you can choose ONLY one of phone types that is
CF62 or MC60 or C60 or M55 for the examples.

Now lets get started::

Software required: Freia build 10 or higher, Siemens Dataexchange
Software v.2.67, Siemens C60 Bootcore & PX5AMD Java Application for
M55.

Unlocking:

1º - First install "Siemens Dataexchange Software v.2.67" software,
power on the mobile phone, connect the cable and run the software. The
phone must be without SIM card inside.

2º - Go to /java/jam/ folder and create a new folder, upload inside the two PX5AMD Java aplication archives (.jad & .jar).

3º - Now power on the "Siemens (phone of choice)" with a SIM card
inside and run the Java aplication. This aplication will ask you for a
code, code = 39116. Then you will see a menu, first select "backup
bootcore", second select “patch bootcore” option and in a few seconds
the phone will turn off. To finish repeat this process again and you
will receive "Already OK" message. In this moment the bootcore will be
patched.

4º - In this stept is very important make a full backup firmware with
"Freia build " software selecting "Siemens (phone of choice)" type
phone. If something goes bad you will have a good backup of your mobile
phone to resolve the problem.

5º Now is time to flash the “patched bootcore C60". Run the software
(Freia build 10), select "Siemens (phone of choice)" phone type , in
"Configuration Functions" options select "Patched bootcore", press on
“Write flash to phone” button, select “goodc60bootcore.zip.fls” flash
file, click on “bootcore” box and press “OK” button. Software will ask
to press ignition button of the mobile phone, press it and the software
will flash the phone in a few.

6º - The final stept is to unlock the mobile phone. Select "Siemens
(phone of choice)" i.e. CF62 phone type, with "Freia build" software
and unlock the "Siemens (phone of choice)" i.e. CF62, with "Direct
Unlock no map is saved" option and the software will unlock the phone
in a few seconds.

Suggestions:

· Mobile phone battery must be full charged.
· Never disconnect the cable while phone is unlocking.
· Is very important select "Siemens (phone of choice)" phone type and
no "Siemens (phone of choice) boot". If you select "Siemens (phone of
choice)" boot", you will kill your phone.
very nice that i need now